Flexera Service Gateway 2
To check if the Flexera Service Gateway 2 certificate is bound to the port, perform the following steps.
To check if the Flexera Service Gateway 2 certificate is bound to the port:
| 1. | Open the Administrator Command Prompt and run the following command: |
netsh http show sslcert ipport=0.0.0.0:9443
The following is displayed:
| 2. | If necessary, use the following command to clean up the certificate: |
netsh http delete sslcert ipport=0.0.0.0:9443
Flexera Service Gateway 2 Installation and Administration Guide15 February 2017 |
Copyright Information | Flexera Software |